Sign In | Join Free | My
Search by Category
Home > Power Transmission >

Taper sleeve installation type

  • Haven't found right suppliers
  • Our buyer assistants can help you find the most suitable, 100% reliable suppliers from China.
  • And this service is free of charge.
  • we have buyer assistants who speak English, French, Spanish......and we are ready to help you anytime!
  • Submit Buying Request
    • Product Details
    • Company Profile

    Taper sleeve installation type

    General principles of selection sprocket teeth

    19 Teeth or more

    Generally used for high-speed running under normal operating conditions the drive sprocket(see various rate power speed conditions)

    17 Teeth

    Only be used for small pitch sprocket,such as 8mm and 8/8" pitch sprocket .See the section above,but only low-speed transmission(refer to various speeds rated power)

    15 Teeth or less

    Must be avoided,unless the spindle speed is lower than 100r/min

    23 Teeth or more

    Recommended for impact situation.When the speed ratio is low,the use of a chain can be significantly reduced draft teeth amount of rotation of chain,the chain tensile load and bearing load.If fewer sprocket teeth for high speed,high load applications,the hardware considered as hardened sprocket tooth surface.

    For single-row chain drive,recommended ratio not exceeding 7:1.for a 5:1ratio over all the gear,the desgner should consider the used of multirow chain drive,in order to improve life.More the a 3:1 gear ratio ,gear ratio ,and its shaft center distance of not less than the sum of sprocket pitch circle diameter. For Vertical shaft drive,always should be a multirow chain

    Buy Taper sleeve installation type at wholesale prices
    Send your message to this supplier
    To: Foshan Huisi Transmission Machinery co.,ltd
    Characters Remaining: (0/3000)
    Inquiry Cart 0